Installation Guide

Follow the simple installation process to properly apply your G-Force Hockey Grip for improved control, comfort, and on-ice performance.

Perfect Setup

  • 1

    Scan & Watch

    To see how to install your G-Force Grip properly scan the QR Code or follow the video in this page.

Scan for Setup
Tap to scan

Scan for Setup

& Training Videos

Hovercode Powered

Step-By-Step Guide

01

Prepare Your Hockey Stick

Clean the hockey stick handle surface before installation. Remove any old grip tape, dirt, or moisture to ensure a secure fit.

02

Test Grip Security

Make sure you have a tight secure fit. You should be able to slide this in without a lot of force. If it is loose use the .75 or 1.25mm EVA Adhesive Condensed Foam. These should go on all 4 sides of the insert of the grip.

03

Stick and Grip Prep

Wipe the inside of the stick and the insert portion of the grip with one of the alcohol wipes.

04

Epoxy

Mix up the epoxy. Cover all 4 sides of the insert and the inside of the stick with the epoxy. Don’t be shy with the epoxy. Push it in to the end of the insert. Turn the stick upside down and hit the end of the handle to secure it fully into the stick.

05

Clean Up

Wipe off all residual glue with the alcohol wipes

06

Heat Gun & Glue Cleanup

If you want to use a heat gun to secure and speed up the curing process you may do so. Limit the heat gun to less than 2 minutes. Wipe residual glue (careful it will be hot) with alcohol wipe.

07

Let cure for 24 hours.

Helpful Installation Tips

Install the grip on a clean and dry surface for the best performance.

Check the grip position before securing it completely.

Replace worn grips regularly to maintain optimal control and comfort.

Store equipment in a cool and dry environment after use.